About this model

Boia de Água 3L — approximate 3D reconstruction for the catalogue and spatial visualisation. Confirmed commercial capacity: 3 litres of water; this is not a linear dimension. External diameter approximately 40 cm; hole and filled height estimated. The mesh does not constitute a measurement or certification of the 3 L volume. Use water only, not sand, as stated on the page. External dimensions are entirely approximate: no complete confirmed dimensioning exists in the sources consulted. Visualisation model, not a technical drawing or assembly validation. GLB in metres, Y up, front +Z and floor Y=0. AR scale based on the actual bounds of this approximate reconstruction. Untextured PBR materials for unprinted surfaces; for the Expo Case, the original image is applied through UV mapping, without pixel editing. Cameras and lights excluded from the GLB. Illustrative 3D model at approximate scale. The dimensions shown relate to the reconstruction; feet, thicknesses and components without complete dimensions were estimated from the official references. Do not use as a technical or manufacturing drawing. Product reference: https://poster.digital/loja/boia-de-agua-3l/ 3D reconstruction notes: Confirmed commercial capacity: 3 litres of water; this is not a linear dimension. External diameter approximately 40 cm; hole and filled height estimated. The mesh does not constitute a measurement or certification of the 3 L volume. Use water only, not sand, as stated on the page. External dimensions are entirely approximate: no complete confirmed dimensioning exists in the sources consulted. Visualisation model, not a technical drawing or assembly validation. GLB in metres, Y up, front +Z and floor Y=0. AR scale based on the actual bounds of this approximate reconstruction. Untextured PBR materials for unprinted surfaces; for the Expo Case, the original image is applied through UV mapping, without pixel editing. Cameras and lights excluded from the GLB.