About this model

Base Wall 45º — approximate 3D reconstruction for the catalogue and spatial visualisation. Wall bracket with an estimated plate of approximately 12×12 cm, four through-holes and a pin at 45° to the vertical. The 45° angle follows the designation; plate, reinforcement, pin and diameters estimated. No wall, flag or installation screws. External dimensions are entirely approximate: no complete confirmed dimensioning exists in the sources consulted. Visualisation model, not a technical drawing or assembly validation. GLB in metres, Y up, front +Z and floor Y=0. AR scale based on the actual bounds of this approximate reconstruction. Untextured PBR materials for unprinted surfaces; for the Expo Case, the original image is applied through UV mapping, without pixel editing. Cameras and lights excluded from the GLB. Illustrative 3D model at approximate scale. The dimensions shown relate to the reconstruction; feet, thicknesses and components without complete dimensions were estimated from the official references. Do not use as a technical or manufacturing drawing. Product reference: https://poster.digital/loja/base-wall-45o/ 3D reconstruction notes: Wall bracket with an estimated plate of approximately 12×12 cm, four through-holes and a pin at 45° to the vertical. The 45° angle follows the designation; plate, reinforcement, pin and diameters estimated. No wall, flag or installation screws. External dimensions are entirely approximate: no complete confirmed dimensioning exists in the sources consulted. Visualisation model, not a technical drawing or assembly validation. GLB in metres, Y up, front +Z and floor Y=0. AR scale based on the actual bounds of this approximate reconstruction. Untextured PBR materials for unprinted surfaces; for the Expo Case, the original image is applied through UV mapping, without pixel editing. Cameras and lights excluded from the GLB.